And the edges?
Edge finishing is very easy but requires a change of habit: From now on, you will not finish the edges before the faces but well after.
You have two options :
-
Either you apply a pre-lacquered veneer edging on the edge. These pre-lacquered edgings are also part of the concept of Aranya. Their application happens exactly as normal edge bands.
However a last detail: once the edging applied and planed, you still have a little corner of about 0.5mm which needs to be protected too. For this purpose, we provide you special stylo felt pen which you will just need to slip along the corner. Check well if it is not necessary to sand it lightly in order to make it smoother.
These stylos are available in the same colours as the faces.
-
Either you only want to chamfer the edge with some device keeping the Mdf raw. This is perfectly possible. You can then finish it with a water-based lacquer which you can apply with a spray gun or a brush. (the polythene film is there to protect the face). This being done, you use the same technique as in the previous case: you peel off the film and you finish the tiny corner with a light sanding followed by the stift application.
